Once the account is created, connect the pool/spa controller to the wireless access point or local router.
This will include a username, a password and an email address.Ĥ. Once the host computer is connected to the wireless access point or local router, create an account using the ScreenLogic software. Connect the host computer to either a local router that contains a wireless access point or a separate wireless access point that is located in close proximity to the host computer.ģ. Download and install the ScreenLogic software on the host computer (the computer that will be attached to the network).Ģ. Setting up ScreenLogic requires an internet connection and can be done with the following steps:ġ. If you still cannot determine why your Pentair system is offline, you may need to contact a professional to investigate the issue further. Lastly, you can check the system’s alarm conditions to make sure there are no issues that are causing the system to read “offline. Additionally, check the system’s sensors to make sure they are in good working condition. If you are able to access the controller, you can check the system’s communication settings to make sure that it is appropriately linked to the control unit. If these are fine, the issue may be with the control unit itself. If the breakers are good, check the power source to the controller and check that the cable connections are secure. Check the breakers in your electrical panel to see if any have been tripped. If the power source has been affected, it could be that a breaker has been tripped.
It could be that there is an issue with the system’s sensors, or the system has extinguished an alarm condition. It could indicate that there is an issue with the power source, or the system is not communicating properly with the parent control unit. If your Pentair system says “offline,” this could indicate a number of issues. Make sure that the components are functioning as expected before end-users start using the system. Test that all the components are working properly: Once the components are connected to the main control unit, test them by using the buttons or controls available. Check the instructions for your brand or model for the steps required to successfully connect the components to the main control unit.Ĥ. Link the components to the main control unit: Depending on the brand and model of your system, you may need to link the components to the main control unit using a computer or a tablet. Make sure all the components are securely plugged in and that the power cord is long enough to reach all of the components.ģ. Connect the components to power: Plug the power cords that come with the wireless components into an approved outlet.
0 kommentar(er)
